rogie@rcn.com
New Member
- Messages
- 1
- Reaction score
- 0
- Points
- 0
I had a plumber install the Groher Pressure Shower valves in my new bathroom. I decided to do the trim myself after the tiling was done. When I turned on the water, with all controls in the OFF position, I was getting water out of the shower arm.
The only question I had during installation was the turning of the Shower Valve screw? It said to make sure it was in the horizontal position. It was, so I didn't touch it. I'm wondering if I should have turned it a few times to OPEN it and then set it to horizontal.
Any ideas?
Marc
The only question I had during installation was the turning of the Shower Valve screw? It said to make sure it was in the horizontal position. It was, so I didn't touch it. I'm wondering if I should have turned it a few times to OPEN it and then set it to horizontal.
Any ideas?
Marc
