I have a three handle tub/shower faucet that is leaking. I replaced the washer but it stills leaks. I tried removing the flange? that the washer sits against but it wont budge and started to strip. There is no access in the rear wall. is there some other way other than removing half the tiles to fix this?
cold water leak
- Thread starter kbrahms
- Start date
hj
Master Plumber
- Messages
- 33,613
- Reaction score
- 1,057
- Points
- 113
- Location
- Cave Creek, Arizona
- Website
- www.terrylove.com
leak
Yes, either get the proper seat wrench for your faucet, or call a plumber and have him remove and replace the seat. It will be a lot easier and cheaper to call a plumber than to replace the valve and repair the wall.
Yes, either get the proper seat wrench for your faucet, or call a plumber and have him remove and replace the seat. It will be a lot easier and cheaper to call a plumber than to replace the valve and repair the wall.
Sponsor
Paid Advertisement
hj
Master Plumber
- Messages
- 33,613
- Reaction score
- 1,057
- Points
- 113
- Location
- Cave Creek, Arizona
- Website
- www.terrylove.com
seat
A plumber with a good seat dresser may be able to renew the surface, but I cannot remember ever having a seat that could not be removed.
A plumber with a good seat dresser may be able to renew the surface, but I cannot remember ever having a seat that could not be removed.
Jimbo
Plumber
On some 3 handle units like P/P, a standard seat wrench will bottom out against the body of the valve before completely engaging the seat. I have always carried a wrench with the first (smallest) seat cut off, for this purpose.
