Quick question with DWV pipe size

jwater7

New Member

Messages

9

Reaction score

0

Points

1

Location

Washington

• Jan 28, 2013

• #1

I have a (hopefully) quick question that I haven't been able to find a straight answer on..

When I put drain pipe in for a lav, code (UPC 2009) requires 1 1/4 in. I've heard you can go up one "nominal" size (so I think that would imply going to 1 1/2 in.). What if you want to grow to 2" or even 3", is there code preventing this? Without getting into if it's really a good idea or not, I'm just wondering if it would pass inspection.

Thanks

 

Jadnashua

Retired Defense Industry Engineer xxx

Messages

32,770

Reaction score

1,195

Points

113

Location

New England

• Jan 28, 2013

• #2

You'd be hard pressed to find really big, pretty lav fittings, but, once it's in the wall, it can become any size larger.

 

Sponsor

Paid Advertisement

• 1 minute ago

• Add bookmark
• ##

 

jwater7

New Member

Messages

9

Reaction score

0

Points

1

Location

Washington

• Jan 28, 2013

• #3

So to clarify, I could have a 1.5" trap/arm going into wall with a 3x3x1.5 santee, even if the lav is the only thing on the branch?

 

Terry

The Plumbing Wizard

Staff member

Messages

29,942

Reaction score

3,483

Points

113

Location

Bothell, Washington

Website

terrylove.com

• Jan 28, 2013

• #4

Most of the time in Washington, we're using a 1.5" trap arm and p-trap.
1-1/4" is the smallest, but you can't find that in ABS.
The 1.5" trap arm can tie into any size that is the same or larger.

I often run 2" over to a lav. That gives me options later on.
The only reason I would run 3" below a lav is if it were used as a cleanout for the nearby toilet.

 

Last edited: Jan 28, 2013

jwater7

New Member

Messages

9

Reaction score

0

Points

1

Location

Washington

• Jan 28, 2013

• #5

Great, thanks for the clarification

 

Cacher_Chick

Test, Don't Guess!

Messages

5,461

Reaction score

214

Points

63

Location

Land of Cheese

• Jan 28, 2013

• #6

Much of the reason behind the pipe sizing is with regard to the flow of material through the pipe. If you use a 3 inch pipe for a lavatory, the flow would not scour the pipe which would allow excessive buildup of solids.

 

Last edited: Jan 29, 2013

hj

Master Plumber

Messages

33,613

Reaction score

1,057

Points

113

Location

Cave Creek, Arizona

Website

www.terrylove.com

• Jan 28, 2013

• #7

I seldom, if ever, use anything smaller than 2" for any drain lines. You COULD use 3", but would have to install a 3" cleanout opening for use if it ever plugged up. There is a "fine line" between being "large enough" and being "oversized" to the point that flow velocity slowed down which can cause stoppages.