Access to tub faucet - size of hole in drywall?

AcidWater · Nov 7, 2012

How big a hole do I need to cut behind the tub faucet to replace it? Want plenty of working room.

The valves are 24" above the floor, the spout about 19". 3 valve type with 8" spacing.

the big question is: How much above & below that should I allow to get to the unions, if present? I want to cut a single piece of drywall out so I can replace it easily.

Its in a closet so I can go large... stud indicator says there's a stud in the middle.

MACPLUMB · Nov 7, 2012

Go stud to stud on the two outside studs that always does it for me

Sponsor · 2022-01-29T12:20:58-0800

hj · Nov 7, 2012

Getting to the unions is not the problem because they are right below the hot and cold stems. Piping to the new valve is where you may have problems. If you go below the tub spout, 6" above the hot and cold handles, and stud to stud, you should be fine.

AcidWater · Nov 7, 2012

Okey Dokey. Hopefully the replacement will fit the existing unions.

JohnjH2o1 · Nov 7, 2012

AcidWater said:
Okey Dokey. Hopefully the replacement will fit the existing unions.

That's not going to happen. Most new three valves, if you can find one no longer have unions. Even if they did they wouldn't fit the old ones.

John

hj · Nov 8, 2012

They MIGHT fit if the new faucet is the same make as the old one, but even then they sometimes change the patterns to make them "lighter", (i.e., cheaper).

AcidWater · Nov 9, 2012

How do union joints differ? Are they brand proprietary?

Gotta cut the hole in the wall today...

Access to tub faucet - size of hole in drywall?

AcidWater

Member

MACPLUMB

In the Trades

Sponsor

Paid Advertisement

hj

Master Plumber

AcidWater

Member

JohnjH2o1

Plumbing Contractor for 49 years

hj

Master Plumber

AcidWater

Member

Similar threads