Where to find 1" Pex manifold?

Benze

Member

Messages

65

Reaction score

0

Points

6

Location

Montreal, Canada

• Sep 16, 2010

• #1

Hi,

Does anyone know where I can find a 1" inlet, 3/4" outlet Pex manifold? I decided to run 1" Pex-C instead of 3/4" Wirsbo, and I'm looking for a mini-manifold from which I can run a handful of 3/4" lines to fixtures and risers.

I've looked at the Watts site, and don't see any there, nor is there anything on PexSupply which I figured would have a good variety.

Does anyone know if these exist and who makes them?

Thanks,

Eric

 

S

seavlad

Guest

• Mar 8, 2012

• #2

1" inlet 3/4" outlet manifold?

Did you find a solution? I'm looking to use a 1" inlet to 3/4" outlet manifold at the start of a trunk/branch design. I'm in the middle of a multiple phase remodel and only need to supply water to the kitchen and one bathroom. This manifold with valves would let me manage that easily and then have room for expansion.

 

Sponsor

Paid Advertisement

• 1 minute ago

• Add bookmark
• ##

 

Ballvalve

General Engineering Contractor

Messages

3,583

Reaction score

45

Points

48

Location

northfork, california

• Mar 8, 2012

• #3

Try the Sioux website....

 

S

seavlad

Guest

• Mar 8, 2012

• #4

Already did and called them as well... only product they have with 3/4 outlets are all sweat connections, really doesn't help me with PEX. Also tried Zurn with no luck and searched the internet.

 

Jadnashua

Retired Defense Industry Engineer xxx

Messages

32,770

Reaction score

1,195

Points

113

Location

New England

• Mar 8, 2012

• #5

You could sweat on copper to pex adapters to the manifold...may be your only choice.

 

Ballvalve

General Engineering Contractor

Messages

3,583

Reaction score

45

Points

48

Location

northfork, california

• Mar 9, 2012

• #6

It only takes an hour to build your own manifold and you can set the spacing and direction of the outlets and valves.

 

Tom Sawyer

In the Trades

Messages

3,625

Reaction score

35

Points

48

Location

Maine

• Mar 9, 2012

• #7

Uponor shows them in their catalog but I've never seen one on anybody's shelf. Better for expansion would be a 1" with 1/2" outlets and a flow through. Just cap the end of the 1" for now

 

T_Hartigan

New Member

Messages

34

Reaction score

0

Points

0

Location

Ohio

• Mar 9, 2012

• #8

I built mine. I have 1" copper and ran 1/2" pex. Couldn't find what I wanted. If you make it yourself it can be just how you want it.

 

hj

Master Plumber

Messages

33,613

Reaction score

1,057

Points

113

Location

Cave Creek, Arizona

Website

www.terrylove.com

• Mar 10, 2012

• #9

manifold

A manifold like that would be counterproductive. The idea for a manifold is to allow you to run multiple smaller lines to the various fixtures, NOT 3/4".