ActionDave
Electrician
Does any one besides Taco make a good multi-zone boiler control box?
Last edited:
Is Taco the only one out there?
- Thread starter ActionDave
- Start date
ActionDave
Electrician
I think I'll make my own.
Sponsor
Paid Advertisement
BobL43
DIY Senior Member
I made my own 5 zone panel, with 1 priority zone for the indirect heater. No biggie, all 24VAC wiring and relay
DonL
Jack of all trades Master of one
That sounds like a plan.
Then you will be able to repair it easy and make it more better than you can buy.
+ You could built it from USA made parts. (If you can find them)
BobL43
DIY Senior Member
I'll scan in my sketched w/d and post it here.
I bought some wood moldings last night at Lowes. They were made in New Zealand. That makes no sense to me
Tom Sawyer
In the Trades
Tekmar makes them so does Amtrol
BobL43
DIY Senior Member
View attachment 15035
Here is the w/d and a photo of the one I built in 2002 . what is not shown here are the 5 zone lamps for the front panel that show when each zone valve is energized
Last edited:
ActionDave
Electrician
Thanks for that. I like Tekmar. I'll look them up.
All donations gratefully accepted- No problem, I'll e-mail you a check.
ActionDave
Electrician
Looks good. I had to tip my lap top up on its side to read the w/d. Good thing I don't have an I Pad.
Seeing that makes me want to build my own, but time is an issue. Not that I mind taking the time but my wife gets envious if I give a project more attention than her.
I do have a whole stack of 24V ice cube relays that a crying out for a higher purpose than collecting dust. Hmmmm.... now I just have to come up with an explanation how this will save us money.
What did you use for the zone lamps?
Last edited:
Similar threads
