Do you have to use a closet bend after a toilet flange?

JoshRountree · Sep 2, 2011

If I wanted to go down about 12 inches after the toilet flange to avoid have to cut joists, can I just use a piece of pipe and a coupler into a wye combo?

Similar to this, but the combo would be on its back for the vertical to horizontal transition.

When do you have to use a closet bend?

What's the difference between a spigot bend, and a hub bend?

hj · Sep 3, 2011

Putting the "Y" on its back introduces new dynamics and we would have to know WHAT is happening upstream of the "Y" to determine if, and how, it could be done. A hub bend uses a section of pipe between the bend and the flange. A spigot bend attaches directly to the flange.

Sponsor · 2022-01-29T12:20:58-0800

JoshRountree · Sep 3, 2011

hj said:
Putting the "Y" on its back introduces new dynamics and we would have to know WHAT is happening upstream of the "Y" to determine if, and how, it could be done. A hub bend uses a section of pipe between the bend and the flange. A spigot bend attaches directly to the flange.

What if the upstream is just a cleanout?

Is a spigot bend similar to a street?

hj · Sep 4, 2011

Then it would depend on WHERE, and how, the vent is connnected. It is a "street" fitting but usually, an INCREASING one.

JoshRountree · Sep 5, 2011

Does Lowes carry closet bends? I went yesterday to pick up some stuff for the washer/dryer rough in and I didn't see a single piece labled "closet bend".

hj · Sep 5, 2011

I do NOT buy my plumbing stuff from Lowes, so I cannot answer that question. It may be that their clientele does NOT know what a closet bend is so they would not buy one even if Lowes sold them. Most DIYers, and some plumbers, use elbows and street elbows to make the toilet connection.

JoshRountree · Sep 5, 2011

hj said:
I do NOT buy my plumbing stuff from Lowes, so I cannot answer that question. It may be that their clientele does NOT know what a closet bend is so they would not buy one even if Lowes sold them. Most DIYers, and some plumbers, use elbows and street elbows to make the toilet connection.

Streets and elbows just as good? What's the advantages of using closet bends?

Can you reccommend a plumbing supply place that might be nationally known, or just go to my local building supply?

Do you have to use a closet bend after a toilet flange?

JoshRountree

Member

hj

Master Plumber

Sponsor

Paid Advertisement

JoshRountree

Member

hj

Master Plumber

JoshRountree

Member

hj

Master Plumber

JoshRountree

Member

Similar threads