Double check my plan

Pghsebring · Mar 30, 2010

I have 3 questions.

First, do i just use a regular 1.5" elbow in the upper right?
Second, do i just use a regular 2" elbow in the lower left?
Third, can i use a 2" santee in the bottom right instead of a 2" wye + 45 (store don't got no combos)?

Oh - and any other problems you see?

- I just realized, you may want to know, this is for a double bowl kitchen sink.

Thank you in advance.

Terry · Mar 30, 2010

The 2" 90 El below the tee on the left would be a long sweep.

The 1.5" 90 el on the vent, can be a vent 90 or a med 90
I normally carry med 90 and long turns, no vent 90'sin the truck.
They are a fitting that is rarely used.

Inspectors like to see a 2" cleanout.

Sponsor · 2022-01-29T12:20:58-0800

Shacko · Mar 30, 2010

Agree with Terry about the ell and a c.o. If your sink bowls are two different depths make sure you put your rough-in low enough for the lowest bowl.

Pghsebring · Mar 30, 2010

Thanks guys, now i just need my third question answered -

Can i use a 2" santee in the bottom right instead of a 2" wye + 45 (store don't got no combos)?

All of this is sitting in one stud bay BTW - less than 16" wide.

Thanks again.

Basement_Lurker · Mar 30, 2010

Yes you could use a santee to make the transition instead of a wye.

I am curious as to why you are trapping each sink, are you just doing it out of preference or is it code where you are?

Pghsebring · Mar 30, 2010

Preference while i have the wall open. I figure it can't hurt. I'm gonna have two sinks, dishwasher and garbage disposal, this makes it easier later i do believe. One sink into wall, disposal into wall, nice and clean.

Thanks for the help.

hj · Mar 31, 2010

Lont turn elbow on the left, sanitary tee on the right, and a tapped c.o. tee in place of the vent tee. 1 1/2" tapped tee meets the requirement for a full size opening, vent tee does not. Why go to all that trouble? There are easier ways to do it, and I only make multiple inlets when it will be a triple sink.

Double check my plan

Pghsebring

DIY Member

Terry

The Plumbing Wizard

Sponsor

Paid Advertisement

Shacko

Master Plumber-Gas Fitter

Pghsebring

DIY Member

Basement_Lurker

One who lurks

Pghsebring

DIY Member

hj

Master Plumber

Similar threads