Did I finally do it right???

GMrules · May 30, 2009

I spoke to a local plumber ans he said that if I came ouot of the wall to a 90 horizontally and then a 90 staright up to sanitary Tee this would be considered a new combination stack and should be ok

Here is pic of I hope my last attempt. is this correct and will I finally pass code?

Thanks for ur help and pls be nice if I messed it up AGAIN

It is straight the camera was on a angle

Redwood · May 30, 2009

Why all the 90's?

Sponsor · 2022-01-29T12:20:58-0800

Gary Swart · May 30, 2009

Sorry, you have an S trap. The problem is the tee in the drain line is too low. The tail piece from the P trap needs to go straight into the tee. The only solution I can see is to cut into the wall, cut the old tee out, and extend the drain pipe upward. Then add a new tee and adapter for the tail piece.

GMrules · May 30, 2009

The pip comes out of the wall 2" above the bottom of the cabinet so I needed to raise it up, so I put the first horizontal 90 to allow me more room to tie into the p trap. the second 90 was to raise it up.

The pipe in the wall comes in horizontal along the wall the same way as the lower pipe I have and then turns up

NHmaster · May 30, 2009

The bottowm of the trap must be below the outlet. You have an S trap there.

Kingsotall · May 31, 2009

That santee looks like it's pointed upwards...

Redwood · May 31, 2009

The pipe in the wall...

Does it run horizontal or, vertical?

Master Plumber Mark · May 31, 2009

It aint pretty

it will work but it is not pretty...

hj · May 31, 2009

drain

If that thing above the tee is an air admittance valve it will work, but so would coming up out of the tee without going sideways first. And just doing what you did, does not make it a combination waste and vent system. To do that would require pipe size changes and other revisions which would have been economically impractical for you.

Cass · May 31, 2009

the AAV is supposed to be as high as possible...that one is to low...The whole thing is wrong but will probably work for a while...just doen't ever try and snake it...

Did I finally do it right???

GMrules

Member

Attachments

Redwood

Master Plumber

Sponsor

Paid Advertisement

Gary Swart

In the Trades

GMrules

Member

NHmaster

Master Plumber

Kingsotall

Plunger/TurdPuncher

Redwood

Master Plumber

Master Plumber Mark

Sensitivity trainer and plumber of mens souls

hj

Master Plumber

Cass

Plumber

Similar threads