Whtdove3
New Member
We had a Toto Drake 1.6 gpf, round seat, installed last week and am very pleased so far. My hubby was a bit taken back by the low water in the bowl, but came out the first day and said, "One flusher...thumbs up!"
Since I made my decision based in information from this site and forums I though it only proper to post. I replaced 20+ year old toilet with a basic round seat Eco Drake. I cannot believe that I can be so enamored with a toilet. This thing is great you flush, everything goes away and the bowl is clean. The first flush I though something was wrong because of the low water flow. One thing I really like is that there is none of the noise or potential parts failure of a pressure assist system. A good gravity design is the way to go!
Thanks
Robert
Toto Drake Installation instructions
Question: Should water and air bubbles come out of the base of the GMax/Korky style inlet valve...(all inside the tank)?
With the Drake, you can use the E bowl with either the S tank or E tank.
I haven't seen an S bowl in some time now.
I can't tell a difference between the two bowls side by side.
I can tell that the tanks use different parts.
Terry
I doubt that will always be the case, but that's another debate.Since water is plentiful and prices are low...
are there any MAPP test results for the Drake II?
800 Grams for the 1.28 gallon version