Kinetico model 60

I have a Kinetico model 60 and I want to remove the meter and clean everything up. I've never done this and don't want to mess up my system. If anyone has any step by step instructions to remove it and put it back I would greatly appreciate it. Thank you.

kinetico

Kinetico is very secretive about their softeners and tries to keep all service to themselves, so they do not publish any self help instruction as far as I know.

hj said:

Kinetico is very secretive about their softeners and tries to keep all service to themselves, so they do not publish any self help instruction as far as I know.

Click to expand...

Do they use an off the shelf valve though? (Autotrol, Fleck, Klack?)

Gary Slusser can likely be of help here.

Probedude said:

Do they use an off the shelf valve though? (Autotrol, Fleck, Klack?)

Gary Slusser can likely be of help here.

Click to expand...

Nope proprietary!

Why do you want to take it apart?

What is it doing it shouldn't or, not doing that it should?

Kinetico or their dealers, especially their resident salesman on most forums, will not tell you how to take it apart except to remove the screws around the clear dial. Then you're on your own and why I say that people should not buy proprietary equipment.

I've taken a few apart but it's been a long time ago so I'm no help except to say they have a lot of small parts inside.

kinetico

The claim it is the only "softener that does not use electricity" so it could not use any standard control. And they also do not give out parts for others to service them either, at least in this area.

biermech said:

I've got a pic of one naming all the parts in the clear cap, but can't figure out how to post it here. Send me an e-mail and I'll send it to you.

Click to expand...

All you have to do is to scroll down below the text box you type a reply in and click on Manage Attachments.