lorunner1213
New Member
- Messages
- 6
- Reaction score
- 0
- Points
- 0
Im sure this has been covered a few times before and i did a search. I came up with another fella who has a similar request. I read a response that said the 256 gets wired in before the high limit aquastat. I have every schematic in front of me and im usually good at reading them but in this case im lost.
Obviousely terminals 8 and 9 are power from the 24V transformer.
The issue i have is what and how do i run for the boiler demand and the boiler contact?
If i wire the 256 in before the high limit does that mean i remove the wire from either the B or R terminal on the high limit and wire the 256 in between?
Obviousely terminals 8 and 9 are power from the 24V transformer.
The issue i have is what and how do i run for the boiler demand and the boiler contact?
If i wire the 256 in before the high limit does that mean i remove the wire from either the B or R terminal on the high limit and wire the 256 in between?
