Hi.
I'm swapping out the taco 007 pump on my old gas boiler. The new one they sold me has a newer style of flange with an inset rubber ring seal, and the old flanges are pretty much flat with maybe some kind of gasket material. Can I just clean up the old flanges on the boiler and install the new one as is with the big fat rubber ring, or should I just replace the motor and cartridge. Unfortunately already have the old pump out so there is no labor to be saved with the plain motor swap.
Hans
I'm swapping out the taco 007 pump on my old gas boiler. The new one they sold me has a newer style of flange with an inset rubber ring seal, and the old flanges are pretty much flat with maybe some kind of gasket material. Can I just clean up the old flanges on the boiler and install the new one as is with the big fat rubber ring, or should I just replace the motor and cartridge. Unfortunately already have the old pump out so there is no labor to be saved with the plain motor swap.
Hans
