(206) 949-5683, Top Rated Plumber, Seattle
Results 1 to 3 of 3

Thread: Dishwasher Air Gap hookup size mismatch?

  1. #1

    Default Dishwasher Air Gap hookup size mismatch?

    Hi,

    I have a dishwasher but no garbage disposal. I want to install an air gap. It's my understanding that the standard sizes are:
    • dishwasher discharge hose: 5/8" ID
    • dishwasher wye sink tailpiece: 5/8" OD (takes 5/8" hose)
    • air gap inlet: 5/8" OD (takes 5/8" hose)
    • air gap discharge: ?

    I just bought new dishwasher discharge hose, 5/8", and a dishwasher tailpiece, copper, 5/8" fitting. They had a number of these in plastic as well, all 5/8", and one straggler with a 7/8" fitting. I'm looking for an air gap with a 5/8" discharge fitting so that I can make the hookup directly from airgap to tailpiece with a single length of hose, using no adapters.

    The only air gaps I can find have a 7/8" discharge fitting, which it seems is used with a garbage disposal. Some websites refer to this as "standard", so I'm thinking there must be a non-standard air gap for connection to a dishwasher tailpiece (5/8") when you don't have a disposal. But I can't find this kind of air gap.

    Does anyone know of an air gap that meets this requirement? Is the only way to do this with a reducer? Am I nuts?

    Last edited by Terry; 09-28-2007 at 08:13 PM. Reason: forgot email notification

  2. #2
    Moderator & Master Plumber hj's Avatar
    Join Date
    Aug 2004
    Location
    Cave Creek, Arizona
    Posts
    25,624

    Default drain

    7/8" is standard and it is the size of a brass branch tailpiece connection. There are 7/8" plastic ones or you just clamp the 7/8" hose down to the size of your connection.

  3. #3
    Master Plumber Dunbar Plumbing's Avatar
    Join Date
    Apr 2005
    Location
    Northern Kentucky/Greater Cincinnati Area
    Posts
    2,943

    Default

    Buy the standard Air Gap with the 7/8" discharge and switch the tailpiece connection to 7/8".

    The reason why I would go with the norm is because if you stick with 5/8" in the full swoop, the dishwasher depending on how fast it discharges will cause resistance and that Air Gap will always be leaking.


    7/8" is the best way to go without any worries. Do not reduce to 5/8" using 7/8" heading towards it; it will back right up to the Air Gap.
    Read what the end of this sentence means.

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •