Reply With QuoteGordon did you ever replace the gasket,if so could you tell me how.
Thank you
serglo@sbcglobal.net
|
|
|
How is the flush valve replaced with the plastic liner in place?
When the cartridge is spun out, how do you thread the new one in place with the liner there?
Texas
http://www.terrylove.com/pdf/veneto_parts_3362.pdf
Last edited by Terry; 06-04-2011 at 11:33 PM.
Gordon did you ever replace the gasket,if so could you tell me how.
Thank you
serglo@sbcglobal.net
Last edited by Terry; 06-05-2011 at 12:04 AM.
How do I replace the fill membrane?? Does the front piece just pull off??
Bumping this old thread.
Any updates on the Porcher toilets.
I am looking to add a Veneto Ii to our house.
the fill membrane is accessed by unscrewing the big white round nut that is attached to the fill arm.... the nut is about 1 1/4 inch.. you can see it in the diagram. it has no reference number and it just above and to the right of the "9" in the diagram.Originally Posted by 808liz
My question is how to replace the gasket which is number "7" in the diagram. it is in there tight and has started to corrode. i have found that using Tidy Bowl tablets in this toilet causes leaks in the seals... and those Clorox Bleach tablets are really bad as they break down the rubber parts.
This is also the original subject of this thread and it was never answered.
Sorry but what is the purpose of this forum if no one is going to help? I doubt any real plumbers would chime in. They probably don't know themselves how to do it.
Last edited by Rongway; 07-23-2012 at 06:21 AM.
Bookmarks