jjvb
New Member
- Messages
- 5
- Reaction score
- 0
- Points
- 0
I need to replace an electric hot water heater. It is on a farm with a well. The water pressure is never very high. I need to gather all the materials then drive 3 hours to do the replacement. I am not sure of what I will find other than the existing lines are a mix of galv and copper of various sizes. I will use Pex as the crawl space is brutal (dirty and cramped). It has one bath, one kitchen sink and a wash machine.
My question is what size of cold water inlet would be sufficient? Would 1/2 inch be large enough? I am planning on using 1/2 on the outlet side.
Thanks.
My question is what size of cold water inlet would be sufficient? Would 1/2 inch be large enough? I am planning on using 1/2 on the outlet side.
Thanks.