PEW
DIY Senior Member
- Messages
- 484
- Reaction score
- 0
- Points
- 16
Brass Shower Drain rubber seal ?
In the attached photo you will see where the screw-in ring has forced the rubber seal inwards. Is this the way it should look? There was a beveled end to the rubber seal which I placed downwards as it seemed to match the shape of the brass housing (there were no directions as to which way it should go).
Any comments?
Paul
In the attached photo you will see where the screw-in ring has forced the rubber seal inwards. Is this the way it should look? There was a beveled end to the rubber seal which I placed downwards as it seemed to match the shape of the brass housing (there were no directions as to which way it should go).
Any comments?
Paul
Attachments
Last edited: