(206) 949-5683, Top Rated Plumber, Seattle
Results 1 to 2 of 2

Thread: Brass Shower Drain

  1. #1

    Default Brass Shower Drain rubber seal ?

    In the attached photo you will see where the screw-in ring has forced the rubber seal inwards. Is this the way it should look? There was a beveled end to the rubber seal which I placed downwards as it seemed to match the shape of the brass housing (there were no directions as to which way it should go).

    Any comments?

    Attached Images Attached Images  
    Last edited by PEW; 12-22-2004 at 07:00 AM.

  2. #2
    Forum Admin, Expert Plumber Terry's Avatar
    Join Date
    Aug 2004
    Bothell, Washington
    Blog Entries


    I believe that the screw-in ring has a taper to it that will match the taper on the rubber sleeve.

    I've been putting the taper "up".

    I run the pipe a little higher too.


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts