I would like to install a water softener and I would just like some advice. I have never done any plumbing before and I just wanted to make sure what I was thinking was correct. The picture I have attached is a picture of the pipes below my water heater. The left 2 pipes are connected to the hot side (output) of the water heater. I am assuming one pipe for each side of the house. Out of the right 3 pipes the one going up goes to the input of the water heater. I am assuming out of the 3 coming out of the concrete, 1 is the main water line in and the other 2 branch to both sides of the house just like I assume the hot water lines do.
I would like to take apart the 3 lines on the right, figure out which is the main water, feed it into the water softener and connect the remaining lines to the output of the water softener so that I have hot and cold soft water. Am I right in assuming the main water must be one of the 3 lines coming out of the concrete or am I missing something ?
Thank you,
Kyle
I would like to take apart the 3 lines on the right, figure out which is the main water, feed it into the water softener and connect the remaining lines to the output of the water softener so that I have hot and cold soft water. Am I right in assuming the main water must be one of the 3 lines coming out of the concrete or am I missing something ?
Thank you,
Kyle
Attachments
Last edited: