davidm66yy
New Member
I just replaced my bathroom vanity valves and supply lines, along with the faucet. All working, but I have a slow, gradual beading of water on the cold supply line, right above where the hose joins to the nut (see attached). It occasionally drips off, but very slow. This supply hose attaches to the valve with a small rubber gasket inside of it. Do I need to tighten the nut harder? It's already pretty tight - is it possible I over tightened and damaged something? Sorry if these are dumb questions, but I'm a beginner at all of this.
Thank you
Thank you