Just replaced the flow diverter in my shower. It is single handle flow control with pin stem diverter beneath that.
The new one--Danco 80971--looked exactly like the removed one, except on removed one, the nylon diverter 'flap' had come off the device. I pulled it out with needle nose pliers
But after I installed the new one, pressing it in and turning on water does nothing; flow is still fully out the tub spout. Any ideas?
The new one--Danco 80971--looked exactly like the removed one, except on removed one, the nylon diverter 'flap' had come off the device. I pulled it out with needle nose pliers
But after I installed the new one, pressing it in and turning on water does nothing; flow is still fully out the tub spout. Any ideas?