nastafarian
New Member
- Messages
- 4
- Reaction score
- 0
- Points
- 1
Hello,
I am adding a new 240v circuit to supply heat to my garage (1500w) and a powder room (500w) directly adjacent.
Given the layout, I would like to run a wire from the panel to a junction box, and then run a seperate wire from the j-box to each room with it's own thermostat/heater. Within the J-box i would connect all 3 red ends together and all 3 black ends together.
My intention is to use 14/2 wire and a 15 amp breaker.
Does this sound safe and correct? Any advice would be greatly appreciated.
Thanks!
Patrick
I am adding a new 240v circuit to supply heat to my garage (1500w) and a powder room (500w) directly adjacent.
Given the layout, I would like to run a wire from the panel to a junction box, and then run a seperate wire from the j-box to each room with it's own thermostat/heater. Within the J-box i would connect all 3 red ends together and all 3 black ends together.
My intention is to use 14/2 wire and a 15 amp breaker.
Does this sound safe and correct? Any advice would be greatly appreciated.
Thanks!
Patrick