1) I have a Fleck 5600 Econominder on a resin tank with .75 cubic ft. of resin. Based on everything I've seen, that amount of resin would have a capacity of about 24,000 grains. However, the cog wheel with the hardness numbers indicates the capacity is 18,000 grains. Should I a assume 24,000 and ignore what the wheel shows?
2) I have seen several version sof the installation manual for the Fleck valve. One said the drain should be no longer than 20 feet and should have a rise no more than 36". Another one made no mention of any limitations. My actual installation has a run of about 40' with a rise of about 48" using 1/2 " PVC. Anyone see a problem here?
2) I have seen several version sof the installation manual for the Fleck valve. One said the drain should be no longer than 20 feet and should have a rise no more than 36". Another one made no mention of any limitations. My actual installation has a run of about 40' with a rise of about 48" using 1/2 " PVC. Anyone see a problem here?