Rehab Adam
New Member
I am moving my tub drain to middle of where tub used to be for a shower drain. See pictures. What is the best way to tie the new shower drain into the main drain? Should I cut two new holes in joists and tee into the toilet drain, then can I use the previous tub PVC for the vent. Or should I change the tub PVC to 2" and use existing holes. My worry is if using the existing holes is that I will have need to use a 90 degree turn where the tub drain used to be to tie in and I will have too many turns.
Also with this previous setup the toilet seemed to plug up regularly should I cut that offset out and make it straight or could it be the wet venting off the toilet drain? Should I redesign the vent for the shower so it is not wet vented?
Last edited: