Hi all,
The tank was loaded with 2 bags of new Morton salt pellets at kick-off in July.
I emptied out most of the pellets tonight from the plastic bin, I did not see any salt bridge.
Not sure what size my brine flow control is. Where do I find that ?
Are these Regen parameters correct?
B1 = 10
BD = 60 (manual says set to 30 for 48,000 system)
B2 = 5
RR = 10
BF = 12
Here are the details of my softener from the datasheet:
Model: 70-SXT-2-48-M
Specs: 10x54" mineral tank, 1.5 cu. ft. of high capacity resin, 18 x 33" brine tank, 2310 brine float, salt platform, 1 1/4" bypass valve, 1.25" connectors, 7000SXT Fleck Metered on demand valve, floor space 29 x 18 x 62"
Capacity: 48,000 grains
I am going to change C=40 (per mialynette2003 recommendation), BD to 30 (per manual) and H to 14 (per mialynette2003). It's due for a re-gen (day 12 of 14) so I'll kick one off tonight. I'll let all know the results.
Thank you.
The tank was loaded with 2 bags of new Morton salt pellets at kick-off in July.
I emptied out most of the pellets tonight from the plastic bin, I did not see any salt bridge.
Not sure what size my brine flow control is. Where do I find that ?
Are these Regen parameters correct?
B1 = 10
BD = 60 (manual says set to 30 for 48,000 system)
B2 = 5
RR = 10
BF = 12
Here are the details of my softener from the datasheet:
Model: 70-SXT-2-48-M
Specs: 10x54" mineral tank, 1.5 cu. ft. of high capacity resin, 18 x 33" brine tank, 2310 brine float, salt platform, 1 1/4" bypass valve, 1.25" connectors, 7000SXT Fleck Metered on demand valve, floor space 29 x 18 x 62"
Capacity: 48,000 grains
I am going to change C=40 (per mialynette2003 recommendation), BD to 30 (per manual) and H to 14 (per mialynette2003). It's due for a re-gen (day 12 of 14) so I'll kick one off tonight. I'll let all know the results.
Thank you.