Donald Allen
New Member
We are about to begin the remodeling of one of our bathrooms. Over the past few years, I have noticed an occasional black-colored water coming from each of our Delta traditional single-handle faucets (installed in 1991) in the double-sink vanity. Not only is water black-colored on occasion, but tiny pieces of what seems to be rubber particles also is outputted from the faucets. Initially, I thought it was the faucets themselves, but in checking, all is fine with the faucets. BTW... these are the old heavy thick-gauge chrome-plated cast brass faucets, not at all like the current Delta traditional Foundations Core-B faucets which are made in China. This black water and rubber particle anomaly only occurs on the hot water line, thus I thought it may be due to the hot water heater, but in checking, all other faucets in the house do not have this problem. Is it possible it could be a problem with the rubber washers in the wall-mounted shut-off valves? After the removal of the faucets, double-sink vanity, etc., I temporarily installed a 36" 3/8" compression line to each hot water shut-off, and sure enough, every so often black rubber-like material is caught in a catch container. I believe the shut-off valves are probably original, and the house was built in the early '70s.
Do you recommend replacement of the shut-off valves (soldered onto copper pipe), or are the rubber washers typically available for these old valves?
Secondly, since my experience with Delta faucets has been excellent, we are looking at their line as possible replacements during the remodeling. However, I have noticed a significant drop in build-quality. Does any company make an affordable full heavy cast-brass faucet these days, or is thin plated brass now the norm? I can't afford the European brands that cost upwards of $1,000 and higher, but certainly can afford to pay for a quality product in the $250 range per faucet.
Any input would be greatly appreciated?
Thanks,
Don
Do you recommend replacement of the shut-off valves (soldered onto copper pipe), or are the rubber washers typically available for these old valves?
Secondly, since my experience with Delta faucets has been excellent, we are looking at their line as possible replacements during the remodeling. However, I have noticed a significant drop in build-quality. Does any company make an affordable full heavy cast-brass faucet these days, or is thin plated brass now the norm? I can't afford the European brands that cost upwards of $1,000 and higher, but certainly can afford to pay for a quality product in the $250 range per faucet.
Any input would be greatly appreciated?
Thanks,
Don