drain help connecting p-trap
- Thread starter annagibs
- Start date
Users who are viewing this thread
You would need a trap apapter.
Either a standard female to trap, or a spigot to trap. The trap side would be a slip joint nut and washer.
The other side would be a solvent weld (glued) fitting.
Either a standard female to trap, or a spigot to trap. The trap side would be a slip joint nut and washer.
The other side would be a solvent weld (glued) fitting.
Sponsor
Paid Advertisement
hj
Master Plumber
- Messages
- 33,603
- Reaction score
- 1,042
- Points
- 113
- Location
- Cave Creek, Arizona
- Website
- www.terrylove.com
Is this question about two different sinks, because one photo shows an elbow and the other one a T?
Yes two different sinks, but same dilemma. I bought a ptrap adapter to plug into the 1 1/2" drain hub. It has threads a washer and hand tighten plastic nut threaded on Is that what is done usually?
Last edited by a moderator:
Yes. We use those trap adapters, either hub or spigot depending on whether you are gluing into a hub or onto a pipe.
The p-trap is tubular and can be assembled using your hands. Easy to remove and work with.
Similar threads
