You could use this http://www.softenerparts.com/SearchR...=18706&Submit= or this http://www.softenerparts.com/SearchR...=13398&Submit=
My 9100SXT twin tank install needs to be close to the wall. I found a 3/4" adapter for the 9100 here, unfortunately my supply line is 1". Would this work or does Fleck have a 1" 90 adapter?
Not sure how those would solve my prob. Looking for a 90 elbow yoke assembly, a 1" version of this:
I mis-understood. Thought you where looking for 1" adaptors to connect piping to the 90 deg yoke.
No problem. I was basing my question on the valve I'm familiar with, the Fleck twinflo, where it opens to the rear. I assumed the 9100 did also, but apparently it opens to the side which solves my wall proximity issue.