theraceman
New Member
Trying to pull a spool out from about 10’ down, but the threads are so corroded that I cannot get the pull pipe to engage.
Is there any advice on a method to get these threads to be usable?
If I just cannot get the treads to work, I was looking at using the 2 slots on each side on the top of the spool, and trying to hook something through those.
Any ideas?
Is there any advice on a method to get these threads to be usable?
If I just cannot get the treads to work, I was looking at using the 2 slots on each side on the top of the spool, and trying to hook something through those.
Any ideas?