Corin
New Member
I am venting my 3'/5' concentric vents horizontally for my new tankless. I admit I was an idiot for doing this, but I already cut the hole in my basement wall, and purchased the horizontal vent kit, but it turns out that the vent now terminates halfway below ground level. Is there any way to make this ok, without having to cut a new hole? I could dig a little hole for it like a window well, and install drainage tiles to ensure it doesn't fill up with water (my house is uphill). Another, more expensive option would be to buy more sections of vents and run them up the exterior of my wall then out away from the house with the 4 degree slope.
Are either of these solutions viable or did I screw myself when I made that hole?
Any advice would be extremely appreciated.
Are either of these solutions viable or did I screw myself when I made that hole?
Any advice would be extremely appreciated.