Philtrap
Member
Folks,
One of the soldered tee connections I just made on a new copper heating pipe installation failed and is dripping about 1 drop per minute. I'm going to fix it, but I was wondering if it was ok to just leave and it will fix itself???? (I've don this before with small thread leaks).
Thanks
One of the soldered tee connections I just made on a new copper heating pipe installation failed and is dripping about 1 drop per minute. I'm going to fix it, but I was wondering if it was ok to just leave and it will fix itself???? (I've don this before with small thread leaks).
Thanks
Last edited: