(206) 949-5683, Top Rated Plumber, Seattle
Results 1 to 9 of 9

Thread: Designing a single well and pump system to supply both irrigation and treated water

Threaded View

  1. #1
    Aspiring Old Fart, EE, computer & networking geek Mikey's Avatar
    Join Date
    Nov 2005
    Location
    Central Florida
    Posts
    2,686

    Default Designing a single well and pump system to supply both irrigation and treated water

    In another thread Dittohead mentioned (http://www.terrylove.com/forums/show...l=1#post384090) that "Irrigation should not be fed off the softener."

    With a single well, pump, and pressure tank, how do you plumb and wire the components so that the chlorine dose to the treated-water flow doesn't get adversely affected by the irrigation use? The chlorinator pump is commonly wired in parallel with the pump, but with an irrigation load, the chlorinator pump would run when irrigation water is flowing, resulting in overchlorination. Controlling the chlorinator with a flow switch in the treated-water line wouldn't detect the many small flows that make up the treated load, resulting in underchlorination. A flow switch in the irrigation line to turn off the chlorinator would help, but if there's a large treated load at the same time, underchlorination results. An extra pressure tank, flow switch(es), and check valve(s) could minimize the problem, especially if the chlorine is injected prior to the treated-side pressure tank, but many pro's don't like that approach. Sensing the chlorine level downstream of the contact tank and using that to control the chlorinator is much better, but introduces a potential time lag in the dosage, and probably costs a ton of money. A small circulation loop across the contact tank feeding the chlorine detector solves the time-lag problem, but doesn't help the ton-of-money problem. A sensitive flow meter controlling a variable-dose chlorinator comes close as well, but also misses small flows, and is also pricey. Any ideas/suggestions?
    Last edited by Mikey; 06-28-2013 at 04:33 AM. Reason: typo

Similar Threads

  1. Help designing the best well system??
    By wmheinz in forum Pumps and Tanks Well Forum & Blog
    Replies: 2
    Last Post: 05-10-2013, 05:29 AM
  2. adding a circulator pump to a single zone system
    By rrcur in forum Boiler Forum
    Replies: 9
    Last Post: 01-10-2012, 05:11 AM
  3. Water Supply Connection for House and Irrigation
    By jasontf in forum Plumbing Forum, Professional & DIY Advice, Tips & Tricks
    Replies: 2
    Last Post: 06-02-2011, 10:00 AM
  4. PVC repair irrigation water supply line from the street
    By themp in forum Plumbing Forum, Professional & DIY Advice, Tips & Tricks
    Replies: 4
    Last Post: 04-28-2011, 05:58 PM
  5. Shallow Well Pump - Constant Short Cycling with Irrigation System
    By Gheuett in forum Pumps and Tanks Well Forum & Blog
    Replies: 7
    Last Post: 09-22-2010, 05:43 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •