burnttoast77
New Member
Hey all, fresh newb here in Savannah, GA.
Here is my plan to rough in my toilet:
Flange connected to:
14" long piece of 3" PVC to:
3" 90 long sweep elbow or closet flange to:
3" sanitary tee.
Lower part of San tee to:
5" long piece of 3" PVC to:
3" 45 elbow to:
3" wye on side, clean-out on one side to:
3"x4"x4" wye hooked up to the cast iron horizontal drain line
And just realized it'd be way better to draw it. I'll try and get that done. I am mainly concerned about the drop right under the toilet flange. I need it to connect the tub waste line above the toilet San tee just wanted to make sure it was kosher.
Here is my plan to rough in my toilet:
Flange connected to:
14" long piece of 3" PVC to:
3" 90 long sweep elbow or closet flange to:
3" sanitary tee.
Lower part of San tee to:
5" long piece of 3" PVC to:
3" 45 elbow to:
3" wye on side, clean-out on one side to:
3"x4"x4" wye hooked up to the cast iron horizontal drain line
And just realized it'd be way better to draw it. I'll try and get that done. I am mainly concerned about the drop right under the toilet flange. I need it to connect the tub waste line above the toilet San tee just wanted to make sure it was kosher.
Last edited: