I know this topic has been posted before but I am basically lost. We have 2 Toto's - both handicap height/enlongated not that it should make a diff. First one installed 2005 in a master bathroom ensuite the second one installed 2008 in a hall bath. The Toto from 2005 had the original flapper with no problems. The 2008 flapper we had to replace after 3 years (2011-ish) which we did with a Toto flapper. It then started leaking again a few months ago so I came back to these message boards to research to see what was up. Figured we weren't going to spend another $20 for 3 years if there was something better. So we bought the Korky 3060BP. We have tried adjusting the settings it will go for days fine and then slowly seep, like for some reason it won't set right. (We have a line on the inside of the tank so we can see when it goes down and we have well water so we hear the pump running). Last night we even turned the water off and this morning the tank was completely empty.
What do we do now? Husband is about ready to get a new toilet at this point.
Any help would be appreciated.
BTW - there are only 2 of us in the house with occasional guests.