filipi
New Member
Hello everyone
I was assembling and gluing ABS pipes and fittings together, and one of the pipe didn't bottom out in the fitting , may be by 1/4". I guess I didn't push hard enough and it dried before I could do anything about it.
Is that still acceptable if not leaking or shall I cut that section and redo it ?
Thanks.
I was assembling and gluing ABS pipes and fittings together, and one of the pipe didn't bottom out in the fitting , may be by 1/4". I guess I didn't push hard enough and it dried before I could do anything about it.
Is that still acceptable if not leaking or shall I cut that section and redo it ?
Thanks.