My water pump sits on top of the water tank, close to the wall where the 2 hoses from the jet pump come thru the wall.
The water has been cutting off for a minute or so, after being run for a while. So I suspect the pump is clogged, maybe just at the pressure sensor.
Wondering if I should maybe start by removing the caps around that area; if I can clean out just the one necessary place, or if that would just be a waste of time.
Taking it off would allow me to disassemble & refurbish anything as well; clean out the impellers, etc. But quite a big job, just making room to get to it & the wet mess, and getting the hoses off & on.
The water has been cutting off for a minute or so, after being run for a while. So I suspect the pump is clogged, maybe just at the pressure sensor.
Wondering if I should maybe start by removing the caps around that area; if I can clean out just the one necessary place, or if that would just be a waste of time.
Taking it off would allow me to disassemble & refurbish anything as well; clean out the impellers, etc. But quite a big job, just making room to get to it & the wet mess, and getting the hoses off & on.