Timbuktu
Member
I was having some issues with my pump tec last summer. it seemed like just connection issues within the pumptec itself.Sometimes the wells pump wouldnt come on,but Re positioning the PTec faceplate usually worked.It functioned normally for the next 7 months then it started acting up again .
I noticed yesterday something different happened. The single reset(1 red button) would kick off,but if i waited a few minutes or so,and reset it it would run the pump as usual.
Then, at some point, a few (4 or 5)resets later, the lights in the pumptec cover plate were completely off(not lit as theyre supposed to be when connected to its box.Sometimes there will be a slight bit of red and green light but not bright like it usually is.
Either way,lights dim or out,the jet still operates,but it no longer activates the well pump.
Any ideas?
I noticed yesterday something different happened. The single reset(1 red button) would kick off,but if i waited a few minutes or so,and reset it it would run the pump as usual.
Then, at some point, a few (4 or 5)resets later, the lights in the pumptec cover plate were completely off(not lit as theyre supposed to be when connected to its box.Sometimes there will be a slight bit of red and green light but not bright like it usually is.
Either way,lights dim or out,the jet still operates,but it no longer activates the well pump.
Any ideas?
Attachments
Last edited: