(206) 949-5683, Top Rated Plumber, Seattle
Results 1 to 3 of 3

Thread: Where to mount shower valve?

  1. #1
    DIY Junior Member Arsinek's Avatar
    Join Date
    Mar 2013
    Location
    Florida
    Posts
    15

    Default Where to mount shower valve?

    I know you mount it with the plaster ground flush to the finish surface but how am I supposed to tell where that is considering the finish surface isnt there?

    Ill be using 5/8 Durock and I dont know what tile yet, something under 12 inches.

    Is there some sort of process to do this?

  2. #2
    DIY Senior Member kreemoweet's Avatar
    Join Date
    Sep 2009
    Location
    Seattle. WA
    Posts
    371

    Default

    It's simply not true that the guards are always set flush to the finished surface: it depends on the valve. It's always a bad idea to set the valve
    at one extreme or the other of the allowed depth: there's always some leeway, and you should use it. You can calculate the wall finish depth closely
    enough, but you gotta have at least some idea if you're using 3/16 mosaic tiles or 1 1/8 stone slabs, etc.

  3. #3
    Retired Defense Industry Engineer jadnashua's Avatar
    Join Date
    Sep 2004
    Location
    New England
    Posts
    21,374

    Default

    I highly suggest you not install the valve until you've chosen the tile! While there's a range of depth where the trim will fit (and that is what the manufactuer considers acceptable) YOU may not like the way it looks if it is at one extreme or the other. If it is too far forward, you wont' be able to tighten the trim up. If it's too far back, the screws nor the handle(s) will fit. SOme manufacturers offer an extension kit, but that may then make it stick out further than you like, but it will fit. Depending on the manufacturer, some have very tight tolerances about depth.
    Jim DeBruycker
    Important note - I'm not a pro
    Retired Defense Industry Engineer; Schluter 2.5-day Workshop Completed 2013, 2014

Similar Threads

  1. Adapting deck-mount tub faucet to wall-mount
    By adrury in forum Plumbing Forum, Professional & DIY Advice, Tips & Tricks
    Replies: 5
    Last Post: 05-09-2013, 06:23 AM
  2. Wall mount tub filler with deck mount controls
    By islandgrl in forum Shower & bathtub Forum & Blog
    Replies: 6
    Last Post: 05-15-2012, 06:17 AM
  3. Replies: 7
    Last Post: 11-23-2008, 08:37 PM
  4. 3 function valve (spout, handheld, wall mount)
    By bingo in forum Shower & bathtub Forum & Blog
    Replies: 1
    Last Post: 01-25-2008, 08:00 AM
  5. What will it take to turn wall mount plumbing into floor mount?
    By Dandilyun in forum Toilet Forum discussions
    Replies: 15
    Last Post: 12-31-2007, 05:26 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •