(206) 949-5683, Top Rated Plumber, Seattle
Results 1 to 4 of 4

Thread: actual door opening width

  1. #1
    DIY Senior Member diyfun's Avatar
    Join Date
    May 2011
    Location
    MA
    Posts
    131

    Default actual door opening width

    I measured the width of my existing door panel and got 27-3/4", it is a 28" wide door or 30" wide door?

    or

    what's the actual door opening width for a 28" wide door? I need to know if the opening is wide enough for a table which is 26" wide.

  2. #2
    Retired Defense Industry Engineer jadnashua's Avatar
    Join Date
    Sep 2004
    Location
    New England
    Posts
    21,408

    Default

    It's a 28" door. But, the actual opening is smaller because of the door stops. If you take the door off, it should just make it through. With it on, you'd have to subtract at least the thickness of the door.
    Jim DeBruycker
    Important note - I'm not a pro
    Retired Defense Industry Engineer; Schluter 2.5-day Workshop Completed 2013, 2014

  3. #3
    Plumber jimbo's Avatar
    Join Date
    Aug 2004
    Location
    San Diego
    Posts
    9,001

    Default

    It is a 28" ( trade size 2-4, meaning 2'4"). Then is was planed about 1/4" at install. So your opening between jambs is close to 28", but subtract about 3/8" each sde for stops.

    A table can be fudged through a much smaller opening, buy easing the legs "around the corner" at the side opposite the hinges

  4. #4
    Moderator & Master Plumber hj's Avatar
    Join Date
    Aug 2004
    Location
    Cave Creek, Arizona
    Posts
    25,655

    Default

    Your table is 26" wide and the door opening is 27 3/4". What is the problem? The only problem would be if the door does not "swing" open far enough to give you the full opening, in which case, remove the hinge pins and put the door off to the side somewhere.
    Licensed residential and commercial plumber

Similar Threads

  1. door opening
    By jetlag in forum Remodel Forum & Blog
    Replies: 10
    Last Post: 10-14-2010, 06:31 PM
  2. Garage Door Opening Wall 2x4 or 2x6?
    By Lakee911 in forum Remodel Forum & Blog
    Replies: 2
    Last Post: 08-11-2009, 01:50 PM
  3. Garage door in RO less than door width?
    By jrfiero in forum Remodel Forum & Blog
    Replies: 2
    Last Post: 06-19-2009, 05:36 PM
  4. Swinging shower door opening too small
    By shirleybouncy in forum Shower & bathtub Forum & Blog
    Replies: 1
    Last Post: 01-24-2009, 05:09 PM
  5. Rough Opening for Door
    By nelsonba in forum Remodel Forum & Blog
    Replies: 11
    Last Post: 11-21-2007, 03:36 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •