jimktm
New Member
Hi all
Bath #1: Toilet must fit under a low countertop which is 29 3/4 from floor to underside. Counter sticks out 7 3/4 from wall. 11 1/2 rough-in to finished drywall. Toto Drake CST744E (1.28gpf) and CST744S (1.6gpf) have a spec height of 28 1/2. Sounds tight -- will this be enough room with tank lid off to service tank parts in the future?
Bath #2: This bath has no countertop to deal with. I'd like to put same toilet in, but it's only 10 7/8 rough-in to the finish side of a ceramic tile wall. Toto spec https://terrylove.com/pdf/cst744sg-specs.pdf
shows if 12 to wall you have 1 1/8 rear clearance. So with my 10 7/8 to wall, it would be zero clearance. Will this work, or is there a better choice? I have room to go any height.
Also, is 1.6gpf legal in California still? I assume 1.6 is better (helps avoid dry drain, etc.)
thanks for any advice, Jim
Bath #1: Toilet must fit under a low countertop which is 29 3/4 from floor to underside. Counter sticks out 7 3/4 from wall. 11 1/2 rough-in to finished drywall. Toto Drake CST744E (1.28gpf) and CST744S (1.6gpf) have a spec height of 28 1/2. Sounds tight -- will this be enough room with tank lid off to service tank parts in the future?
Bath #2: This bath has no countertop to deal with. I'd like to put same toilet in, but it's only 10 7/8 rough-in to the finish side of a ceramic tile wall. Toto spec https://terrylove.com/pdf/cst744sg-specs.pdf
shows if 12 to wall you have 1 1/8 rear clearance. So with my 10 7/8 to wall, it would be zero clearance. Will this work, or is there a better choice? I have room to go any height.
Also, is 1.6gpf legal in California still? I assume 1.6 is better (helps avoid dry drain, etc.)
thanks for any advice, Jim
Last edited by a moderator: