I use PEX.
After 3 month of use, I just noticed that about a 10 Ft section of the flexible tubing used for the drain line on the condensate pump has collapsed. From the furnace to the ceiling, it is flatter than a pancake. It must be too soft to maintain its shape. This can't be normal and will not drain well.
Can anyone tell me how my contractor should fix the problem and why this even happened?
Well, the HVAC guy replaced the entire piece of 3/8 inch flexible vinyl flexible tubing that ran from my condensate pump to the laundry room tub. The entire piece was flat as can be. He said he never saw anything like it in his 20 years on the job.
I wondered if when I chlorinated my well, the chlorine somehow did this…but that is hard for me to believe.
Can you tell me how that picture by my username gets displayed when I post a message. I like it, but I never posted a picture to use.
Terry picked the photo based on your location. You see mine is baskets of apples. Well, in reality, I don't think any apples in Yakima, WA were ever picked in baskets, in fact bushel boxes haven't been used for years. But, the point is of course, apples and Yakima are very closely connected.
Last edited by Gary Swart; 01-17-2013 at 01:56 PM.
Well, for you HVAC folks out there, as it turns out, my furnace contractor had twice used the wrong quality 3/8 vinyl tubing.
The stuff for HVAC use that they were suppose to use is made by a company called Diveristech. This is thicker wall tubing. They used:
C1011EZ 3/8 x Ĺ