Hello and thanks for any tips here ..

Was putting together the overflow and drain kit on my Kohler tub, it is all white PVC and I was using the clear (700 I think) glue..

Long story short we had the tub tilted up to make this easier and some of the glue ran back down the PVC pipe and into the tub where it is now dried around the drain area .... about a 4 inch long trail of it ..

Are there any tips / solvents that will get this off the tub without leaving a mark? I have no clue if a thinner or remover will also take off some of the tub finish..

I highly doubt any of the pro's here has ever had that happen but am sure some of your hired help have done it once or twice ...

Thanks again.. checks in the mail!!