Can you reuse brass fitting when working with PEX

[Crassius]

Maybe this is obvious to some, but I want to be sure to avoid headaches in the future...

I want to replace a valve in a PEX run, and plan on removing the existing valve by removing the PEX by cutting the crimp ring off one side of a brass elbow like the one pictured.

I would then crimp new PEX pipe onto side of the elbow from which I cut the ring.

Will this work, or am I inviting trouble by reusing the elbow?

[Terry]

If you are careful you can reuse the fitting.

[dlarrivee]

You have lots of room to cut the ring off without damaging the elbow, if the elbow still has all it's barbs on it you're good to go.

[hj]

Some PEX kits come with a crimp ring remover that does what you want to.