DOCSCANTLIN
New Member
Since you have the ledge/shelf inside the drain line fitting hole, I'd be left with counting threads on the shaft that tightening exposes.
Now just yet I don't know if I'd count thread valleys or peaks. I would want to stop short as opposed to going too far/tight though and test it to see what suction I have and adjust if not a strong suction.
Of course that assumes there is no other causes of weak or no brine suction. I'd look for no water flow out the brine line fitting hole or the brine line itself when the pistons are in the service or other cycle positions except for Refill.
I'd count thread peaks and keep my lucky charm close by while silently repeating - Please God help me get this right....
Mr. Slusser, what shaft? The threads on the cap drive assy. are internal and the piston rod shaft has nothing to do with the spacer stack position...?
...another wrinkle...When I get a 1002 error, I cannot get a rest by pushing reg. and next. I have to unplug for over an hour to get a reset...????
The brine line never leaks, by the way...