(206) 949-5683, Top Rated Plumber, Seattle
Results 1 to 4 of 4

Thread: Well pump mounting question

  1. #1
    DIY Member rayh78's Avatar
    Join Date
    Sep 2008
    Location
    Virginia
    Posts
    77

    Default Well pump mounting question

    Is this normal?

    Have a well at a rental property. Works great and water clear.
    Has a submersible pump. But concrete cover does not sit tight because it rest on a pipe.
    So a gap all around. Is this normal?

    If you remove the cover there is about 30 of galvanized pipe laying across the opening.
    This seems to be used to hold the pump suspended in the center of the well. Then a cable runs down to the pump.
    Has 1 of the black poloy pipe that runs down to the pump.
    I am guessing they just did not want to have only the pipe holding the pump. Pipe goes thru the wall of the well about 24 down from the top of the well casing. Has a plastic/poloy elbow, which I guess may otherwise break from the weight of the pump.

    What Is normal?

    Thanks

  2. #2
    DIYer, not in the trades LLigetfa's Avatar
    Join Date
    Feb 2011
    Location
    NW Ontario, Canada
    Posts
    3,690

    Default

    "Normal" is to hang the pump on a pitless adapter.

  3. #3
    DIY Member bcpumpguy's Avatar
    Join Date
    Jul 2012
    Location
    Langley BC
    Posts
    70

    Default

    around here that is quite common. If you want to use a pitlless adapter i guess it would work but you would have to have a few feet of steel pipe sticking out of the culvert to keep the pump from pulling the pitless down. In a cement culvert i would not reccomend hanging the pump close to the culvert wall as it sometimes tends to pull in silt and sand. I would also not recommend to bury steel pipe. What i usually do is to take a piece of copper pipe and flatten out the ends to set on top of the casing. If you want to get fancy, drill two holes in the concrete opposite of eachother and stick some steel pipe into that.

  4. #4
    DIY Senior Member craigpump's Avatar
    Join Date
    Apr 2012
    Location
    ct
    Posts
    717

    Default

    1/2" gap? Just enough for all kinds of critters to find their way into the water supply. Figure out a way to seal that well properly, chlorinate the complete system and then test for bacteria.

Similar Threads

  1. Mounting a New Boiler
    By MarkeyHall in forum Boiler Forum
    Replies: 5
    Last Post: 08-20-2012, 06:25 AM
  2. Submersible pump in cistern mounting/installation
    By boerdoc in forum Pumps and Tanks Well Forum & Blog
    Replies: 4
    Last Post: 05-26-2012, 12:37 AM
  3. Toilet mounting question
    By DIY Duder in forum Toilet Forum discussions
    Replies: 5
    Last Post: 12-20-2009, 08:16 AM
  4. Mounting a AS Glenwall
    By aviator_edb in forum Toilet Forum discussions
    Replies: 1
    Last Post: 10-16-2008, 06:55 AM
  5. under counter white lav. mounting
    By Dan Thomas in forum Remodel Forum & Blog
    Replies: 1
    Last Post: 08-17-2008, 06:32 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •