Tub spout removal?

[paperprofit]

Need to remove my tub spout (for new surround). Tried turning it counterclockwise to unthread it but it didn't budge. Do I need to use a strap wrench, perhaps, or could there be a locking screw hidden that needs to be loosened first? Faucet assembly is Delta or Moen. Thanks, guys!

[jadnashua]

There are essentially two ways to hold the tub spout: threaded, or push on. If it is push on, then there will be a setscrew accessable from somewhere on the bottom. It might be recessed, and seeing it can be a pain. A mirror might help along with a bright light.

Keep in mind that if they used silicon to seal it to the surround, that acts like a VERY strong glue, and you have to break that seal first regardless of how it is attached.

[hj]

Delta will usually be screw on, but Moen is usually set screw, but they could be either one. WIthout being there we cannot tell you which you have.

[paperprofit]

Thanks again, guys! I found 'Moen' stamped on the valve escutcheon and I was able to force it the spout to turn with a strap wrench (since I saw no set screw). BUT, the spout STILL won't come off. (I'm turning it counter-clockwise as I stand inside the tub). Did I miss a set screw somewhere? Thank you so much for any suggestions! Anxiously waiting! (I'll post a photo I took, if you think it would be helpful, as soon as I find the cable for my Blackberry.)

[Terry]

A set screw would be visible under the spout in a small slot. It uses an allen wrench.

[paperprofit]

Terry, No luck. There is no set screw. I'm quite certain. I checked throughly. Should I just yank hard?n Thanks!