(206) 949-5683, Top Rated Plumber, Seattle
Results 1 to 2 of 2

Thread: Whirlpool Flame Lock Heater Often Fails to Maintain Hot Water ("False" Status Light)

Hybrid View

  1. #1
    DIY Junior Member
    Join Date
    Jul 2012
    Location
    Oregon
    Posts
    1

    Default Whirlpool Flame Lock Heater Often Fails to Maintain Hot Water ("False" Status Light)

    Hi, I have a Whirlpool Energy Smart gas water heater with flame lock that all of a sudden often fails to maintain a tank of hot water throughout the day (has never done this before). One time I take a hot shower, then after a few hours, no hot water. I go to the heater and the status light indicator says normal (1 flash every 3 seconds) and the pilot light is still lit. Another time was before showering (ugh).

    This happens throughout the day and every time I go check the heater, theres a normal indicator light and the pilot light is lit, it just refuses to crank up any gas/heat unless I reset it by turning the heater off for a few mins and turning it back on; pilot light stays lit, it fires up without any problems and I get hot water after a few minutes. This has been my band-aid solution but its getting annoying.

    I have little sense of any of this and dare not mess with anything for fear I will do something stupid/unsafe. Also have a CO and smoke detector next to my heater for safety. I have searched a little through the stickied Whirlpool thread here but it seems that most people have a completely failed thermocouple and their pilot lights won't light at all, but mine works fine per se. Any advice would be appreciated.

  2. #2
    In the Trades Gary Swart's Avatar
    Join Date
    Sep 2004
    Location
    Yakima WA
    Posts
    7,246

    Default

    As you probably realize, this is not a favored brand. My best advice is to call a service man that is familiar with the Whirlpool heaters. I know you are looking for an inexpensive DIY fix, but sometimes that just isn't possible.

Similar Threads

  1. Replies: 613
    Last Post: 03-06-2014, 03:58 PM
  2. Remote "On / Off" indicator light for a submersible pump?
    By riverside67 in forum Pumps and Tanks Well Forum & Blog
    Replies: 5
    Last Post: 05-28-2011, 11:24 PM
  3. Installing 1/2" NTP Grundfos recircultion pump on 3/4" NPT Water Heater
    By CountryBumkin in forum Plumbing Forum, Professional & DIY Advice, Tips & Tricks
    Replies: 5
    Last Post: 04-21-2011, 06:15 AM
  4. Vinyl glazing around glass piece that is "side light" to shower door
    By watson524 in forum Shower & bathtub Forum & Blog
    Replies: 2
    Last Post: 02-06-2011, 05:32 PM
  5. Jacuzzi "Espree" corner whirlpool
    By hsullivan in forum Shower & bathtub Forum & Blog
    Replies: 3
    Last Post: 07-04-2005, 11:33 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •