Aprialaire 8600 thermostat

Users who are viewing this thread

jerry.colangelo

New Member
Messages
1
Reaction score
0
Points
0
Location
Georgia
Replaced Honeywell with Aprialaire 8600 due to temp being off many degrees.

No issues with the Honeywell other than this.

Aprialaire runs blower fine on heat, circ, and all the time.

When the unit calls for ac the blower on the furnace starts slow then after a second or two blows as normal. Like you slowly exhale then let it all out.

Furnnace and compressor a Heil ans 3,5 ton Rheem 17 w coil witha thx valve. One speed on both units.

Could this be a feature of the 8600 to draw low amps then when it gets the ok all is well ramps up? No ac guys can give me an answer and Aprilaire is closed today.

Ac guys said capicator issie vut told them with the old stat all was fine and rhis issue is only when the 8600 makes a call for ac.
 
Top
Hey, wait a minute.

This is awkward, but...

It looks like you're using an ad blocker. We get it, but (1) terrylove.com can't live without ads, and (2) ad blockers can cause issues with videos and comments. If you'd like to support the site, please allow ads.

If any particular ad is your REASON for blocking ads, please let us know. We might be able to do something about it. Thanks.
I've Disabled AdBlock    No Thanks