Here is what I've installed.
Here is what leaks. It's Blue Monster Pipe Thread Sealant.
Only the hot water "in" leaks. but I'm assuming this is not how it's done. I should have probably soldered the fittings after tightening them the best I could?
If soldering this close to the plastic workings inside do I remove them like I did for the mixing valve?
Any help/scrutiny/criticism is welcome and much appreciated.
Thanks,
Mike
Here is what leaks. It's Blue Monster Pipe Thread Sealant.
Only the hot water "in" leaks. but I'm assuming this is not how it's done. I should have probably soldered the fittings after tightening them the best I could?
If soldering this close to the plastic workings inside do I remove them like I did for the mixing valve?
Any help/scrutiny/criticism is welcome and much appreciated.
Thanks,
Mike