Here is what I've installed.
Name:  7004400434_993da69cf6.jpg
Views: 1318
Size:  25.1 KB
Here is what leaks. It's Blue Monster Pipe Thread Sealant.
Name:  7004397386_dc5f5f1c39.jpg
Views: 440
Size:  87.0 KB
Only the hot water "in" leaks. but I'm assuming this is not how it's done. I should have probably soldered the fittings after tightening them the best I could?
Name:  7004400064_a11bb6066b.jpg
Views: 690
Size:  24.4 KB
If soldering this close to the plastic workings inside do I remove them like I did for the mixing valve?

Any help/scrutiny/criticism is welcome and much appreciated.

Thanks,

Mike